From: TW (TDW123) [#3]
31 Oct 2006
To: Stunt Engraver (DGL) [#2] 31 Oct 2006
Thanks for the lead.
I will try and contact him tomorrow.
From: Tom Franklin (FLEA) [#4]
31 Oct 2006
To: Stunt Engraver (DGL) [#2] 31 Oct 2006
My opinion is that Fred Swartz is the most knowledgable person concerning New Hermes machines.....even better than the company (nothing against the company intended)
From: Harvey only (HARVEY-ONLY) [#5]
31 Oct 2006
To: TW (TDW123) [#1] 31 Oct 2006
The max value is determined by the table, vague memory that it is 1000 per inch. Negative numbers are forbidden.
The PLT file might control the Z up and down commands but not the depth of cut and the lift over the material. It is a specialized PLT format that they use.
Getting the software is useless without the dongle. The dongle will cost probably over $3000.
I am unfamiliar with the 9200 and 8000.
EDITED: 31 Oct 2006 by HARVEY-ONLY
Show messages: All
1-2
3-5