From: Stunt Engraver (DGL) [#17]
15 Mar 2007
To: MR C (MOSHE) [#16] 15 Mar 2007
$45-$50 sounds more worthwhile, than $25-$35.
Cost is less than bronze, which should be appealing to the customer and in the quantities you mentioned, enough money to make it worth your while.
It's a good combination. :-)
Good luck!
From: Engravin' Dave (DATAKES) [#18]
15 Mar 2007
To: MR C (MOSHE) [#14] 16 Mar 2007
May I ask who your supplier is at these rates? Is it a Canadian supplier?
From: Engravin' Dave (DATAKES) [#19]
15 Mar 2007
To: MR C (MOSHE) [#7] 16 Mar 2007
I can't remember how long it took to engrave the small piece in the photo. I know I had to run it three times with my 30-watt laser to get a reasonable depth. I actually should have run it one more time.
A higher-powered laser is the tool for this substrate. Routing may also be okay if fine detail is not required.
Show messages: All
1-16
17-19