From: Colin (MATROPHY) [#15]
18 Aug 2005
To: logojohn [#14] 18 Aug 2005
Thanks - if you didn't know, the holes in the Allgraphics vice are 1/8" and 3/16" diameter. I bought some brass rods from a hobby supply store that I use to cut longer pins with. I like the Allgraphics vise. It allows me to do a lot more stuff.
From: Colin (MATROPHY) [#16]
18 Aug 2005
To: logojohn [#14] 18 Aug 2005
By the way - what hole spacing did you use to drill the block - what's the distance center-to-center between the holes?
From: Colin (MATROPHY) [#17]
18 Aug 2005
To: Colin (MATROPHY) [#16] 18 Aug 2005
I know I can measure myself - it looks like 1.5" but if you already know what it is...
From: Stunt Engraver (DGL) [#18]
18 Aug 2005
To: ALL
Thanks to everyone for making this a very informative thread. Between the Bondo molds (and other materials) and the various vise/jig solutions, Colin should be able to tackle this job.
Looks like there are numerous "Stunt Engravers" in our ranks! :-)
From: logojohn [#19]
19 Aug 2005
To: Colin (MATROPHY) [#17] 19 Aug 2005
I used 1.5
I made a layout the size of the block with the holes drawn.
I printed it out and positioned it on the block for drilling.
The holes can be a little off and oversized and still hold the block when the vice is closed.
Show messages: All
1-14
15-19