Full Version: Evaluation of IKONmetal ?

From: PenTrophy (PENINSULATROPHY) [#30]
30 Mar 2007
To: Mike (MIKEN) [#29] 30 Mar 2007

The warping can be overcome if you have a heat press or I guess an oven. Heat to 180 or so . The material is flexible (resin) then place on a flat surface until cool.

EDITED: 30 Mar 2007 by PENINSULATROPHY

From: Mike (MIKEN) [#31]
30 Mar 2007
To: PenTrophy (PENINSULATROPHY) [#30] 30 Mar 2007

Mark:

Thanks for that info. I'll give it a try.

If this stuff engraved a little faster I think I could use a lot of it but I can easily see an hour of engraving for an 8x10 piece.

Show messages: 1-9 10-29 30-31

Full Version: Evaluation of IKONmetal ?

Back to thread list | Login

© 2025 Project Beehive Forum