Full Version: Lasering on brass

From: Becky (KIAIJANE) [#10]
 29 Jan 2007
To: smitty [#1] 29 Jan 2007

Without knowing what settings you are using, I would suggest a slow speed with a high power. Brass absorbs heat like a sponge so you have to make sure the power is high to make a mark. At least, that was the explanation I got when I tried brass. I'm certainly no scientist LOL.
Becky

---

From: smitty [#11]
 30 Jan 2007
To: ALL

Yep, it had a finish on it, but I got lucky and got the Cermark to lay on pretty good. I took Stunt Engravers suggestion and ran the laser across it first, then applied the Cermark and ran it again. They came out real nice. Thanks much!

---

From: Stunt Engraver (DGL) [#12]
 30 Jan 2007
To: smitty [#11] 30 Jan 2007

Always love to hear a success story Smitty. :-)

Congratulations!

---

Show messages: All  1-9  10-12

Back to thread list | Login

© 2025 Project Beehive Forum