Full Version: Need info on Sterling silver
From: Stunt Engraver (DGL) [#11]
8 Feb 2007
To: smitty [#10] 8 Feb 2007
Smitty,
That's what I said for much of the time I was in the engraving insustry (1971 to present).
Didn't make my move until 1990.
Better late than never. A daunting move it was, but one of the most rewarding as well.
From: Harvey only (HARVEY-ONLY) [#12]
8 Feb 2007
To: smitty [#10] 8 Feb 2007
I am not sure of the speeds of an 8000, never saw one in operation.
Does it have an EP controller? (Does it use cartridges or connect to a computer?)
If it connects to a computer NH has newer software that can make setup faster than the old Open System software that you had to set up even the baselines of each line. The newer software shows the layout on screen rather than having to do a screen draw and wait until it gets around to slowly drawing it.
From: smitty [#13]
8 Feb 2007
To: ALL
From: Harvey only (HARVEY-ONLY) [#14]
8 Feb 2007
To: smitty [#13] 8 Feb 2007
If it has an EP module there are no cartridges. The fonts are limited by the computer software. It sounds like the Open System software, not really that open. Corel Draw can output to a PLT file directly.
I know that the NH Gravostyle 98 program can drive that unit through the EP module. Maybe Gravostyle 5 also, but not sure. It is what-you-see-is-what-you-get software (WYSIWYG). It is so easy to use if you have any experience with Corel. Quite a bit different but with similar graphic interface.
I do not know if NH still sells 98 or what price it would be, but it is good engraving software. If you buy it be sure to negotiate for free font packs.