Full Version: Should I Buy 25W Laser Engraver?
From: David Wilhite (DAVID-ULS) [#72]
20 Mar 2007
To: ALL
Hi Carl,
I’m not exactly sure why you’re experiencing problems when swapping accessories in and out of your VL-200. I would suggest you check to be sure the honeycomb cutting table and rotary fixture are seated securely on the recessed electrical connector and aligning pins. Also, check to be sure that all of the electrical pins are free of dirt and debris and that none of them are bent or broken. If that doesn’t fix the problem, send me a PM with your machine’s serial number and I’ll work with our service department to find a solution for you.
All the best,
Dave
From: laserman (MIKEMAC) [#73]
20 Mar 2007
To: Carl (CSEWELL) [#71] 20 Mar 2007
Carl,
What version of software do you currently have? (you can find it in the VCP under about).
From: Carl (CSEWELL) [#74]
20 Mar 2007
To: laserman (MIKEMAC) [#73] 21 Mar 2007
From: laserman (MIKEMAC) [#75]
21 Mar 2007
To: Carl (CSEWELL) [#74] 21 Mar 2007
Carl,
I will e-mail you a newer version of the software.
The current version is 1.28.5
Show messages: 1-11 12-31 32-51 52-71 72-75