Full Version: NH Orbiter-EP Module
From: Harvey only (HARVEY-ONLY) [#1]
1 Jun 2005
To: ALL
Quite a while ago someone posted about being able to connect the EP Module to the Orbiter. We sent a few emails back and forth, then my computer had a fatal crash due to a Norton program.
I lost the email information and could not remember who it was.
I now have an Orbiter and an EP module that I can experiment with but need a little information of how to do it by someone who already has. [It will make life much simpler.] I already know that I need to change the motor fuse to a 6A SB. Any other hardware changes? Which program in the EP module works best? Which output machine from a driver program works best? I have a few ideas, but why reinvent the wheel?
EDITED: 9 Aug 2006 by HARVEY-ONLY
From: Harvey only (HARVEY-ONLY) [#2]
9 Aug 2006
To: Harvey only (HARVEY-ONLY) [#1] 9 Aug 2006
I know it was switching two wires and eliminating one limit switch, but do not even remember if it was the X axis or Y axis that needed it.
Any help available. Big fishing trip here.
EDITED: 9 Aug 2006 by DGL
From: bruce (BBSD) [#3]
9 Aug 2006
To: Harvey only (HARVEY-ONLY) [#1] 9 Aug 2006
From: Harvey only (HARVEY-ONLY) [#4]
9 Aug 2006
To: bruce (BBSD) [#3] 9 Aug 2006
From: Harvey only (HARVEY-ONLY) [#5]
10 Aug 2006
To: bruce (BBSD) [#3] 10 Aug 2006