Full Version: Cutting Anodized Aluminum
From: Shaddy [#4]
29 Sep 2005
To: LaZerDude (C_BURKE) [#1] 29 Sep 2005
http://www.idplates.com/
Maybe Frank from Chewbarka can help. chewbarka8898 at yahoo dot com
Shaddy
From: LaZerDude (C_BURKE) [#5]
29 Sep 2005
To: Harvey only (HARVEY-ONLY) [#2] 29 Sep 2005
Harvey,
When you say thickness are you referring to the amount of anodization on the aluminum? If so, I was going to use just plain off the shelf laser engravable aluminum from JDS probably.......
From: LaZerDude (C_BURKE) [#6]
29 Sep 2005
To: RALLYGUY (RALLYGUY1) [#3] 29 Sep 2005
Brian,
The only equiment that I have to do this with at this time is my laser.
From: LaZerDude (C_BURKE) [#7]
29 Sep 2005
To: Shaddy [#4] 29 Sep 2005
Shaddy,
Thanks I'll look into them.
From: Harvey only (HARVEY-ONLY) [#8]
29 Sep 2005
To: LaZerDude (C_BURKE) [#5] 30 Sep 2005
I meant the thickness of the aluminum. A metal shear tends to twist thin aluminum when it cuts a narrow, long piece.
If you do not have a shear you must order the stuff precut.