Full Version: stainless problem
From: Barbara (RGILE) [#13]
18 Jan 2006
To: baz (RINGROAD) [#7] 18 Jan 2006
I have a 30W LaserPro and have no problem with Stainless Steel.
I use a setting of 20 speed 100 power. I also use 300 DPI
and it seems to work fine for me.
I do not know why epilog would not do that also.
Are you spraying on the Cermark? Perhaps its too thick and is not going trough it properley.
Also, found that engraving it twice does not work. It just lasers out the Cermark and looks silver again.
Hope this helped a little.
Barb
From: joepafan (GPERZEL) [#14]
21 Jan 2006
To: ALL
Hi All;
I can almost guarantee that the problem is the stainless has a protective coating on it - usually a lacquer.
George