Full Version: Shear cutter for trophy plates
From: logojohn [#3]
17 Jan 2006
To: Becky (KIAIJANE) [#1] 17 Jan 2006
I raved about one we found awhile back and since then I bought a second one as we have 2 people cutting often. We already had 2 conventional shears.
Here is the message and you might want to read that whole thread for some other ideas.
http://www.engravingetc.org/forum/index.php?webtag=EE&msg=1145.13
I wouldn't go much cheaper than that. If you are going to be doing a lot you will be glad you bit the bullet and got some good equipment.
Main trophy and others have several corner notchers and hole punches.
we use the model 9353 the most but also have the one with the interchangeable dies for 1/2 inch round corners and bigger notches.
.
From: Harvey only (HARVEY-ONLY) [#4]
17 Jan 2006
To: Becky (KIAIJANE) [#1] 17 Jan 2006
Both prior posts give excellent advice.
Let me add strongly that the 3-in-one from Main Trophy may only punch, round one size, it is far better than the one with interchangeable dies. [The depth is adjustable so a simulation of different notches is available.] It is truly a production quality unit and outshines the results of the other one.
I own both and have not used the cheaper one in years.