Full Version: Shears, Corner punch, beveler
From: Awardsguy [#8]
5 Feb 2006
To: ALL
I have a Maxi Press and 2 Accu-Cutter shears, one for plastic and 1 for metal. The combo blades are okay, but a plastic shear is MUCH better because the blade is razor sharp.
I also have Accu-Cutter corner punches and that's the only way to go. If you need something other than a 1/4" cove corner you just put in the new cutter and you have a 1/2" or whatever including some of the fancy corners. The cutters cost a little, but they go a LONG time before they need resharpening.
From: basehorawards [#9]
6 Feb 2006
To: LaZerDude (C_BURKE) [#7] 6 Feb 2006
Chuck,
Yes I am. I like the adjustablility that is built in to it. I also like that when I change from the cornering table to the edge table (for punching holes in the side of a plate) and then switch back I will just need to fine tune it if any adjustment is needed at all as the adjustment screws are spring loaded and independent of the screws that lock the table in place.
EDITED: 6 Feb 2006 by BASEHORAWARDS