Full Version: Shears, Corner punch, beveler
From: basehorawards [#9]
6 Feb 2006
To: LaZerDude (C_BURKE) [#7] 6 Feb 2006
Chuck,
Yes I am. I like the adjustablility that is built in to it. I also like that when I change from the cornering table to the edge table (for punching holes in the side of a plate) and then switch back I will just need to fine tune it if any adjustment is needed at all as the adjustment screws are spring loaded and independent of the screws that lock the table in place.
EDITED: 6 Feb 2006 by BASEHORAWARDS