Full Version: ARA engraver exhibitors?
From: Engravin' Dave (DATAKES) [#4]
8 Feb 2006
To: Puck (PUCKERBRUSH) [#3] 8 Feb 2006
Puck,
Are you familiar with any of the manufacturer reps near you in Kuna, ID? If not, get an informal rating of your area manufaturer and service reps from the other shops in your area. This is an importantf actor and will help narrow down the choices. Depending on your product mix, below are a few on the usual suspects.
Xenetech
Gravograph-New Hermes
Newing-Hall
Quest (Quality One Engravers)
Vision
Roland
EDITED: 8 Feb 2006 by DATAKES
From: Stunt Engraver (DGL) [#5]
8 Feb 2006
To: Puck (PUCKERBRUSH) [#3] 8 Feb 2006
Your old machine sounds repairable. A new one may be in order, but it's always nice to have a back-up.
From: Puck (PUCKERBRUSH) [#6]
8 Feb 2006
To: ALL
Good advice on checking reps. I'll see what I can find out.
Thanks for pointing the links out, hadn't looked in there. Has some good places to check out.
Depending on the repair for the old machine I need to have something to do these engraving jobs and soon. I might have to out source them and not looking forward to that. I can do some on the small engraver but theres some that I just can't do with it.
Thanks,
Puck