Full Version: Dog tags domed
From: Stunt Engraver (DGL) [#37]
30 Apr 2006
To: Puck (PUCKERBRUSH) [#36] 30 Apr 2006
I was just giving you a hard time. (devil)
My message was meant to be good-natured and I hope it was taken as such.
I've only used one-part UV cure epoxy, but if I were to dome anything for outdoor use, I'd go with two-part.
EDITED: 30 Apr 2006 by DGL
From: Puck (PUCKERBRUSH) [#38]
30 Apr 2006
To: Stunt Engraver (DGL) [#37] 30 Apr 2006
Stunt Engraver,
Well, you did make me think about the "sensitive" part but figured you was just leading me on!
Two part stuff is just beyond me since I have the hardest time getting the mix just right. Probably won't do to much outdoor stuff except stuff for myself. PT needs some fancy wheel inserts to go with the ghost flames, going to do something there and see how the UV resin works out.
I was wondering how the pet tags will hold up so did place one in water and left it for 12 hours, withstood that just fine so now the outside test. With this weather a couple days should tell me something hopefully.
Puck
From: Stunt Engraver (DGL) [#39]
30 Apr 2006
To: Puck (PUCKERBRUSH) [#38] 30 Apr 2006
As far as proper measurements of two-part epoxy, some brands come in a two-part syringe, which assures the proper blend, but I believe you have to wait until you have a decent run of items, because you'll have to use the entire syringe-full in one sitting.
I'm not positive about that last statement.
EDITED: 30 Apr 2006 by DGL
From: Ken D. (KDEVORY) [#40]
30 Apr 2006
To: Ken D. (KDEVORY) [#35] 30 Apr 2006
From: Puck (PUCKERBRUSH) [#41]
30 Apr 2006
To: Ken D. (KDEVORY) [#40] 30 Apr 2006
Ken,
I'm really not to sure on the printing on paper so this might be a dumb question but is there a special ink that has to be used or can you just use a regular inkjet printer?
Puck
From: Ken D. (KDEVORY) [#42]
30 Apr 2006
To: Puck (PUCKERBRUSH) [#41] Unread
Show messages: 1-16 17-36 37-42