Full Version: Hand Engraved sword!
From: Harnihal [#1]
28 Sep 2004
To: ALL
Hello everyone..
My name is harnihal (i know bit difficult to pronounce) i am new to this forums....i am a gun enthusiast too and always loved the guns with engravings the most ,i have a questions for experts how much can customised hand engraving on sword which is probably 30 inches long 2 inches wide can cost including hilt which had gold inlays can cost from a hand engraver
Thank you i look forward for replies
Harnihal sidhu
From: Harvey only (HARVEY-ONLY) [#2]
29 Sep 2004
To: Harnihal [#1] 29 Sep 2004
Welcome to the board. I am sure some people here have done swords, I tend to remember a few discussions.
I am sure someone will jump in with some answers.
As far as hard to pronounce, try my last name, Lentchner.
From: Hand Engraver (ENGRAVERON) [#3]
30 Sep 2004
To: Harnihal [#1] 30 Sep 2004
Hi and welcome,
My name is Ron Huntington and I do a lot of hand engraving, but not on what you are talking about. There are quite a few variables that need
to be found out before a cost is established. I would look at a web site
of someone like Sam Alfano. Do a google seach for hand engravers and
I am sure that you will find many examples of what you need.