Full Version: Jim Williams, CRM
From: Stunt Engraver (DGL) [#1]
21 Mar 2006
To: ALL
During the past ARA Las Vegas show, Jim received his Certified Recognition Master (CRM) classification from ARA.
Keep your eyes out for an upcoming article, written by Jim, in "Recognition Review" (ARA trade mag).
Writing an article for the magazine is a prerequisite to a person achieving ARA's CRM status.
Congratulations Jim!
From: John (ICTJOHN) [#2]
22 Mar 2006
To: Stunt Engraver (DGL) [#1] 22 Mar 2006
David,
ARA dropped the "published" requirement awhile back.
Now you must write a paper AND if they feel it is good enough, they will refer it over to the magazine editor............ I just talked to Daniel Weinstock about this very subject in Las Vegas as I am getting close to finalizing the CRM as well. I am not a journalist or even a hack writer, so I was concerned about the PAPER. Turns out I can select any relevant subject and fire away.
:P
From: Stunt Engraver (DGL) [#3]
22 Mar 2006
To: John (ICTJOHN) [#2] 22 Mar 2006
Thanks for updating my knowledge of the CRM requirements. I really don't know much about the certification program.
This tidbit was something I read on Jim's forum.