Full Version: Speed & Power Settings for Mask
From: Engravin' Dave (DATAKES) [#9]
5 Apr 2006
To: JimK (JUSTTHE4OFUS) [#7] 5 Apr 2006
Jim,
When you vector the material, you will also create an outline that will end up being deeper than the rest of the blast. I would not recommend vectoring, but it can be done.
Another factor you need to take into account the amount of time you would spend weeding your image.
From: PenMan [#10]
6 Apr 2006
To: ALL
From: Stunt Engraver (DGL) [#11]
6 Apr 2006
To: PenMan [#10] 6 Apr 2006
Chris,
I've seen duct tape and sometimes masking tape used in areas where etching isn't desired.
I suppose the thickness of the covering would depend on how hard you're going at it, with regard to nozzle pressure and the depth you're trying to achieve.
EDITED: 6 Apr 2006 by DGL
From: PenMan [#12]
6 Apr 2006
To: Stunt Engraver (DGL) [#11] 6 Apr 2006