Full Version: Press recommendation?
From: Engravin' Dave (DATAKES) [#8]
8 Apr 2006
To: JimK (JUSTTHE4OFUS) [#1] 8 Apr 2006
Jim,
This is a timely thread, as I just finished replacing the switch, AC cord receptacle, AC cord and all internal wiring on my DK20S.
My press is about five years old and had limited use the first couple of years I owned it. The balance of time it has had fairly consistent use.
On March 30th, I fired my press up for a job and the display came on like it always does. I created my transfers, cut my metal and was ready to press, then discovered the display was off and the temperature was warm at best.
I checked my breaker switch and determined that wasn't the problem. I then loosened a couple screws to access the internal wiring and discovered a lead had arced and melted part of the switch. I have discovered that over time, the amount of amperage running through these presses, along with the heat generated, takes its toll on the connectors.
I talked with Aaron Knight about my problem and he sent out a $25 kit with all new wires, connectors, a switch, receptacle and cord. It took me all of ten minutes to switch everything out and be up and running.
There have been some frightening experiences with older models of this press. In the opinion of people with more technical electrical knowledge than I, there were some older models that had a fairly inferior wiring design, which has now been cleaned up in the newer models.
Would I buy a Knight Press again? In spite of my issues with some of their past products, it would likely be at the top of my list.
Choosing between the Combo and the DK20S, I would choose the DK20S, which excels at flat pressing. If you want to do mugs, get a serious full-wrap mug press.
EDITED: 8 Apr 2006 by DATAKES