Full Version: What's the difference
From: Harvey only (HARVEY-ONLY) [#5]
14 Jun 2006
To: Mick [#4] 14 Jun 2006
Moderator's privilege is invoked for this post.
Mick's paper is wonderful for the process of CLTT. He has also always been an upstanding business person.
From: logojohn [#6]
14 Jun 2006
To: Mick [#4] 14 Jun 2006
Is it different than the fiberglass reinforced plastic used for sublimation?
Is it as thick as the FRP?
Does it profile cut better with a rotary cutter? or even with the laser?
I assume any normal rowmark or IPI plastic would melt even with the laser toner.
.
From: Mick [#7]
14 Jun 2006
To: logojohn [#6] 16 Jun 2006
Logojohm
I have found most plastics to work quite well. I bought a fairly large quantity of what I felt was the best white plastic for not warping and excellent adhesion. It is totally different than the FRP from Unisub. I have it in 1/16" for name badges etc. in stock in 12" X 18" sheets. It cuts beautifully with the laser, we have had it cut with both a 40 watt and a 120 watt laser so far. Haven't tried a rotary cutter but I think it would be fine. My little 12" shear works very well also.
The Rowmark and similar materials for engraving work very well with the OEM toner too.
Mick
Cactus Equipment & Supplies
800-440-6847
EDITED: 14 Jun 2006 by MICK