Full Version: Diamond/Carbide Burnishers
From: Stunt Engraver (DGL) [#5]
23 May 2004
To: Rose (RSLIEPKA) [#4] 24 May 2004
Rose,
I assume you're making one pass. What you're seeing is part of the gold dye remaining in the engraved characters.
You'll either want to make two (drag) passes or use a (rotary) diamond burnisher, which, in one pass, will not only remove the remnants of gold dye, but give a polished, almost laser-engraved look.
I've also seen some people remove the "left-overs" by pressing masking tape onto the engraving and pulling out the remnants.
David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA
EDITED: 23 May 2004 by DGL
From: Rose (RSLIEPKA) [#6]
24 May 2004
To: Stunt Engraver (DGL) [#5] 24 May 2004