From: Swami [#1]
17 Jun 2006
To: ALL
I purchased some crystal balls, a customer would like his company's logo on it, i have created the mask, im having much difficulty in putting it around the ball, ideas anyonw?????
From: Stunt Engraver (DGL) [#2]
17 Jun 2006
To: Swami [#1] 19 Jun 2006
Working on a compound curve will be difficult (as you're discovering).
You may have to change the size of the logo to something more manageable, size-wise.
From: Harvey only (HARVEY-ONLY) [#3]
17 Jun 2006
To: Swami [#1] 19 Jun 2006
Study the crystal ball carefully till your eyes cross. It may then tell you how to do it. :O
>.<
From: UncleSteve [#4]
18 Jun 2006
To: Harvey only (HARVEY-ONLY) [#3] 18 Jun 2006
WOW! It really WAS a rough day!
;-)
Just think about how many Dads you made happy!
From: Harvey only (HARVEY-ONLY) [#5]
18 Jun 2006
To: UncleSteve [#4] 18 Jun 2006
Yes, did a lot for a lot of Dads. But felt really bad that I could not find even 5 minutes to call you back. Maybe the emails I answered early this AM will help with my apology.
From: Carl (CSEWELL) [#6]
18 Jun 2006
To: Swami [#1] 19 Jun 2006
Get yourself a grapefruit about the same size as the crystal balls. Carefully peel the grapefruit, keeping it in 1-piece as much as possible. When you get done peeling it, place it in your scanner and get a nice scan. Run it through CorelTrace and then import it into CorelDraw. Send it to your laser with a flat sheet of masking material on the laser table. Carefully weed the mask and apply it to the crystal ball........
;^)