Full Version: EGX300
From: Mido [#1]
27 Jun 2006
To: ALL
I have Roland EGX 300 and I engraving sam relief in wood.
After one hour I see that spindle motor is warm.
So, my questions is:
-How long can I set in motion my machine?
-Am I put wrong parameters for X,Y,Z axis if I choice default parameters for hard wood?
-Does motor have any protection from heating ( to turn off or something else)?
-I think that level of noise is higher when I go deeper. Is that ok?
EDITED: 27 Jun 2006 by MIDO
From: Harvey only (HARVEY-ONLY) [#2]
27 Jun 2006
To: Mido [#1] 27 Jun 2006
Going deeper puts more load on the motor & bit and the noise increases.
Most motors are rated for a 55* F temperature rise at full load. Nearly hand burning temperatures. It it only feels warm, not very hot, it should be no problem at all.
From: Mido [#3]
27 Jun 2006
To: Harvey only (HARVEY-ONLY) [#2] 28 Jun 2006
I have spindle control on my machine (from 5000 to 15000 rpm)
What value is best for wood engraving?
Wher can I find some 3D cliparts for download for 3D engraving?
From: varn (VARNCO) [#4]
29 Jun 2006
To: Mido [#3] 29 Jun 2006
3d Vector art...
From: Mido [#5]
29 Jun 2006
To: varn (VARNCO) [#4] 29 Jun 2006