Full Version: ArtCam
From: Mido [#1]
30 Jun 2006
To: ALL
From: gingem [#2]
1 Jul 2006
To: ALL
From: clay (CLAY_J1955) [#3]
1 Jul 2006
To: Mido [#1] 1 Jul 2006
I used it in the early versions of the programs, lots of bugs ie.....the fill routines were very poor. I have since heard its a lot better. As gingem stated, most likely a big learning curve, but it is very powerful. If you currently have a backgroung in cad/cam software its the complete opposite of what you would be used to. In the end I did all my 3d in a program called Rhino and then imported it into a program called Alphacam to write the g-code.
good luck
clay