Full Version: Tiles
From: Ian (IANHR) [#1]
20 Jul 2006
To: ALL
I'm using EngaveLab 7.1 and I've inadvertantly managed to divide my working desktop into "tiles" which means the machine only engraves to the edge of this virtual tile, then stops. Then goes back to the left and starts engraving over what I already have engraved. I don't know how I managed to get these "tiles" and I sure can't see any way to get rid of them in any of the manuals I have. What did I do and how can I undo it? Anybody else out there using EngraveLab? Thanks a ton in advance for any suggestions.
Ian
EDITED: 21 Jul 2006 by DGL
From: Jerre (LAZAFFAIR) [#2]
21 Jul 2006
To: Ian (IANHR) [#1] 21 Jul 2006
If all else fails, call Cadlink Tech Support!
Jerre