Full Version: Sublimation or OEM
From: jpkevin [#7]
12 Feb 2007
To: cindy (ROBERTM) [#1] 12 Feb 2007
From: logojohn [#8]
12 Feb 2007
To: ALL
If I have a large run of something I can ususally find the right temperature and procedure (pad, rotate and repeat, dwell time, peel cool or hot, etc.) But usually requires several test pieces to get the settings exact. Not something I want to use yet for onzie twozies.
Even then it is normal for one or several done exactly the same way in a series to not come out right. (Some or all of the color peels off, doesn't stick or the paper sticks too much or doesn't survive the fingernail durability test.)
There is also the problem of overheating, melting or warping engraving plastic or even thicker acrylic. I have only tried metal a couple times but that doesn't seem foolproof yet either.
It is still a handy tool for some things. It has bailed us out several times when an asi supplier messed up an order at the last minute and we had to figure out plan B.
If there is a sublimation option available like metal, FRP or the limited selection of products, that is my first choice for color marking even if the per piece cost is more. It is much more dependable for even quick onzie twozies and rare that I can't get good results on the first attempt.
From: Harvey only (HARVEY-ONLY) [#9]
12 Feb 2007
To: logojohn [#8] 20 Feb 2007
- Press temperature is varying.
- Press pressure is varying.
- Not enough pressure. Try a little more. Not too much more.
- The substrate may have some stuff on it. Even a hair of a smudge of adhesive from a peel off sheet will make a non-stick surface.
- The first piece needs about 5 seconds more than the rest.
Hope something here may be helpful.