Full Version: LaserBuzz Yacht-Including Plans

From: Harvey only (HARVEY-ONLY) [#5]
 15 Aug 2006
To: Buzz [#1] 15 Aug 2006

OK, let's see if I got this right. (Finally found the access to the right pages, drive crashes are a bummer.)



http://engravingetc.org/Harvey/upload/22640YACHT_assembly.cdr

http://engravingetc.org/Harvey/upload/22648YACHT_CUT_1.cdr

http://engravingetc.org/Harvey/upload/22653YACHT_CUT_2.cdr

From: Buzz [#6]
 15 Aug 2006
To: Harvey only (HARVEY-ONLY) [#5] 15 Aug 2006

Thanks for doing that for me Harvey, I can't seem to figure out the computer stuff without messing things up. Back when I had DOS I think I deleted my autoexec.bat twice. We all have our limitations :S 

From: Harvey only (HARVEY-ONLY) [#7]
 15 Aug 2006
To: Buzz [#6] 15 Aug 2006

It is not an easy thing to do, unless you have the specialty software that John programmed for the forum. It is easy to use, and members do not have access to it, only moderators.

From: Buzz [#8]
 16 Aug 2006
To: Harvey only (HARVEY-ONLY) [#7] 16 Aug 2006

I'm not sure anyone knows this design is available on this thread?

I think they all looked at the picture post and didn't realize we added the design later?

How do I start a thread under Laser Engraving and put the link to the design on this thread?

I just did a product design for someone in less than 15 minutes and I can't figure out this, I feel stupid. :S 

From: Harvey only (HARVEY-ONLY) [#9]
 16 Aug 2006
To: Buzz [#8] 16 Aug 2006

Thread will be renamed to compensate.

From: Dave Jones (DAVERJ) [#10]
 16 Aug 2006
To: Buzz [#8] 16 Aug 2006

Tom, linking to another thread is easy. Go to the post you want to link to and in the upper right of the post you'll see either something like: "4588.8 In reply to 4588.7 " or if the post was to "ALL" then you'll just see a single number, like "4588.1".

Put your mouse over the first number and right click. Then select "Copy Link Location" if using FireFox, or "Copy Shortcut" if using IE.

Then start your new thread or go to the post you want to add the link into and then right click and select "Paste".

From: Harvey only (HARVEY-ONLY) [#11]
 16 Aug 2006
To: Buzz [#1] 16 Aug 2006

Buzz

I just moved this thread to 'Templates', it belongs there. There is no advertising going on so it did not need to go into the 'Advertising' folder.

I am going to have to dig up your other freebies and put them there also.

Thanks for all of your work.

From: Buzz [#12]
 16 Aug 2006
To: Harvey only (HARVEY-ONLY) [#11] 17 Aug 2006

Sound good to me, I have a place to go :O 

Show messages: All  1-4  5-12

Back to thread list | Login

© 2024 Project Beehive Forum