From: gt350ed [#4]
28 Sep 2006
To: PenMan [#1] 28 Sep 2006
All of our trophy plates are engraved/marked using our laser and Romark Flexibrass. We use either Brushed Gold/over black or Brushed Aluminum/over black. We buy it in quarter sheets and we have our supplier (JDS) apply the 3M film adhesive on the back. This is the only way to go. And, in most cases, it CAN be removed and re-positioned as necessary.
From: PenMan [#5]
28 Sep 2006
To: ALL
Thanks to all. I was leaning towards the Flexibrass but did not realize JDS would attach the adhesive. That sounds like the way I need to go since I can't engrave on brass, yet (but soon I hope). That will be another topic.
From: PenTrophy (PENINSULATROPHY) [#6]
28 Sep 2006
To: PenMan [#5] 29 Sep 2006
you can engrave on black, blue, green, purple, red, brass or alum.....
Ahhhhhh you can't cut it, I bet!
EDITED: 28 Sep 2006 by PENINSULATROPHY
Show messages: All
1-3
4-6