Full Version: Help!

From: BrianC (INKSQUIRTER) [#3]
 1 Oct 2006
To: BWC (SPY007) [#2] 1 Oct 2006

Hey Brian,

Don't know when you sent the PM but I haven't received it as yet.


From: bobkat [#4]
 1 Oct 2006
To: BrianC (INKSQUIRTER) [#1] 1 Oct 2006

It sounds like you only need 1 wedge shape that you can cut out of 13 different pieces of stock. If you haven't got it yet, re-post and I will send it to you. I will need to know how big the circle is.

From: BWC (SPY007) [#5]
 1 Oct 2006
To: BrianC (INKSQUIRTER) [#3] 1 Oct 2006

Hi

I am having problems understanding attachments to PM's.
Did not read the whole post and went back to Draw to redo. Will send something when I get it finished.

Brian


From: BrianC (INKSQUIRTER) [#6]
 1 Oct 2006
To: bobkat [#4] 1 Oct 2006

quote:
It sounds like you only need 1 wedge shape that you can cut out of 13 different pieces of stock.


That is true but the angles have to be so that I can piece it back together. Make sense?

This is problem a simple project but I just "ain't" getting it

From: bobkat [#7]
 1 Oct 2006
To: BrianC (INKSQUIRTER) [#6] 1 Oct 2006

How big is the circle; I can send it to you in just a few minutes.

From: BrianC (INKSQUIRTER) [#8]
 1 Oct 2006
To: bobkat [#7] 1 Oct 2006

It can be any size, probably about 10" will do it. Can you maybe explain how you did it so I can give it a go? You can also send the file if you like.

From: Constant [#9]
 1 Oct 2006
To: BrianC (INKSQUIRTER) [#1] 1 Oct 2006

Hi Brian

Try this CDR File

Let me know

Regards Constant
:O 


From: bobkat [#10]
 1 Oct 2006
To: BrianC (INKSQUIRTER) [#8] 1 Oct 2006

Divide your circle into 13 segments 360/13=27.692. That is the included angle of each segment. Draw a 10" circle with a 5" vertical line extending from the center to the top. Change the centerpoint of the vertical line to the same center point as the circle, then go to ARRANGE-TRANSFORMATIONS-ROTATE Tab. Enter the angle (27.692), click "apply to duplicate" several times. Your circle is now divided into 13 equal segments.

From: BrianC (INKSQUIRTER) [#11]
 1 Oct 2006
To: bobkat [#10] 1 Oct 2006

Thanks! I had all the measurements to get the angle but just couldn't git er done....a bow to you sir!

From: BrianC (INKSQUIRTER) [#12]
 1 Oct 2006
To: Constant [#9] 1 Oct 2006

Thank You Constant,

Everyone was a big help.....this was something I knew how to do and forgot.....the mind is a terrible thing to waste.


From: BrianC (INKSQUIRTER) [#13]
 1 Oct 2006
To: ALL

Thank You everyone for your help!

The final result attached....


Show messages: All  1-2  3-13

Back to thread list | Login

© 2024 Project Beehive Forum