Full Version: Dahlgren Wizzard - ?????
From: UncleSteve [#11]
31 May 2004
To: Harvey only (HARVEY-ONLY) [#8] 31 May 2004
Harvey,
Don't know if it is a PC or XL model.
Seller says it is operational so I think I will take the plunge and give it a try.
Gotta start sometime. I spoke to a tobacco store here and he asked if I will be able to engrave cigar cutters for gifts..... told him I didn't see why not. Let the fun begin! ;~)
Steve
From: Harvey only (HARVEY-ONLY) [#12]
31 May 2004
To: UncleSteve [#11] 31 May 2004
The only thing to be careful of is the 'Z' setting. If you forget to set the spindle the workpiece distance, the baseline will shift. That is due to the rotational drop of the spindle rather than a vertical drop.
I believe that is the one big mistake made by the designers. Simply the spindle rotates about an axis which is on the left side of a circle, and the bit is on the bottom of the circle. Every .010 off in the height is .010 shift in the baseline. It could have been reduced by a lot if the hinge was in the right place. Still an amazing feat being the first computerized engraver made, (the original Wizard, not XL or PC.) The XL added an external cart for storage which does have some software problems. If you need to know those ask me.
From: Stunt Engraver (DGL) [#13]
31 May 2004
To: UncleSteve [#11] 31 May 2004
Steve,
A functioning Wizzard, at that price, is more than enough to engrave lighters, cigar cutters, small plates for humidors, and trophies etc.
I think you're wise by taking this opportunity to get your foot in the door. You won't regret it.
David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA