Full Version: Is This The Future
From: Geezer (ERNIE) [#5]
31 Oct 2006
To: Harvey only (HARVEY-ONLY) [#3] 31 Oct 2006
This might answer your questions
http://www.ceramicindustry.com/CDA/Articles/Feature_Article/ebb4f67934bfd010VgnVCM100000f932a8c0
Ernie
Edited an oops in addy
EDITED: 31 Oct 2006 by ERNIE
From: Geezer (ERNIE) [#6]
31 Oct 2006
To: Stunt Engraver (DGL) [#4] 31 Oct 2006
David
The test printer was "drop-on-demand"
Ernie
From: Stunt Engraver (DGL) [#7]
31 Oct 2006
To: Geezer (ERNIE) [#6] 31 Oct 2006
I'm not sure what drop-on-demand is, but in any case, since they're not talking about transfer technology, I assume a direct-to-substrate printer is used.