Full Version: Basic Shapes (change)

From: Jer (DIAMOND) [#1]
 8 Dec 2006
To: ALL

I need to use the basic shape that looks like a triangle with the top point cut off. I sorry I don't know the geometric name of it. My problem is I need to round the corners a little like when the shape tool is used on a rectangle. Does anyone know how to round the corners on this? I have Corel 13.

From: JHayes55 [#2]
 8 Dec 2006
To: Jer (DIAMOND) [#1] 8 Dec 2006

Jer - I will attempt to explain this as best I can. Go to the Basic Shape on your left tool bar and get the flyout - pick basic shapes - then go to the your top tool bar and you will see a slanted rectangle - press the arrow key - you will then see your triangle with the top cut off - select it.
Then to round the corners you will need to go to the top tool bar and select windows - dockers - fillet/scallop/chamfer - you will get that docker flyout - from there select fillet and the radius you wish on the corners then click apply - you will get a message that it is going to change you shape to curves - click OK

It is simple once you have done one or two - experiment a little with the basic shapes and the filet/scallop/chamfer docker

Hopefully you can follow all that - I do not teach Corel - obviously :-$

From: Jer (DIAMOND) [#3]
 8 Dec 2006
To: JHayes55 [#2] 8 Dec 2006

Hey thanks. That will work. I knew where to get the shape, rounding the corners was where I was stuck.

From: JHayes55 [#4]
 8 Dec 2006
To: Jer (DIAMOND) [#3] 8 Dec 2006

Glad to help - I think that docker is new in 13 - I do not remember it in earlier versions but it is quite handy.

From: Jer (DIAMOND) [#5]
 9 Dec 2006
To: JHayes55 [#4] 9 Dec 2006

I got back on the job, got my shape but can not find fillet/scallop/chamfer in my docker. I searched in Corel help and can't find anything. Is it possible this docker is not available in 13?

From: bluepaw [#6]
 9 Dec 2006
To: Jer (DIAMOND) [#5] 10 Dec 2006

Windows
Dockers
It is about the 20th. selection down the list.

From: JHayes55 [#7]
 9 Dec 2006
To: Jer (DIAMOND) [#5] 10 Dec 2006

BluePaw is exactly correct - got to windows then Dockers (down about 7)
then down 20 to fillet/scallop/chamfer. I think this is new in 13

From: Jer (DIAMOND) [#8]
 10 Dec 2006
To: JHayes55 [#7] 11 Dec 2006

Here is the problem. I said I have 13. The fact is I have Corel 12. You guys should know what I have, not what I said I have. I feel pretty stupid now. Now I am wondering what business I am in, is it engraving or engineering?

From: JHayes55 [#9]
 11 Dec 2006
To: Jer (DIAMOND) [#8] 11 Dec 2006

In your case you may have a hard time finding it in X3 if you only have 12 :P

Don't feel bad we all do something stupid from time to time.

If you can send me the specifics of the drawing you want I will try to make it for you and send it to you in V12.

Otherwise I suggest that when you can upgrade to x3 - I love it after getting used to most of the new upgrades in it.

Back to thread list | Login

© 2024 Project Beehive Forum