Full Version: Metal shear suggestions
From: Laser Image (LASER_IMAGE) [#1]
29 Dec 2006
To: ALL
I have decided that it's time to buy a metal shear and corner shaper. I have been doing the research and it seems that the Accu Cutter is the way to go. I do need to cut 12" so it seems the 2001 model is what I need. I am also looking at their cornermate cutters.
Any opinions about this equipment or an alternative brand/model?
I don't know what kind of volume I'll be doing with it, but I would bet it will start out small and grow pretty quickly.
thanks in advance!
Gary
From: Stunt Engraver (DGL) [#2]
29 Dec 2006
To: Laser Image (LASER_IMAGE) [#1] 29 Dec 2006
Gary,
The Accu Cutter is the perennial favorite metal shear.
For corner rounding/hole punching, I like the 3-in-1 Maxi Press from Main Trophy Supply.
http://www.maintrophysupply.com/presses.htm
EDITED: 29 Dec 2006 by DGL
From: Laser Image (LASER_IMAGE) [#3]
29 Dec 2006
To: Stunt Engraver (DGL) [#2] 29 Dec 2006
From: Stunt Engraver (DGL) [#4]
29 Dec 2006
To: Laser Image (LASER_IMAGE) [#3] 29 Dec 2006
Ideally, you'll have two shears. One for metal and one for plastic.
Since most of the material I shear is metal, I use one shear and change the blade, for plastics, when necessary. (4 bolts)
Note: If you go that route, don't forget to change the blade back for metal. >.<
From: LaZerDude (C_BURKE) [#5]
3 Jan 2007
To: Laser Image (LASER_IMAGE) [#1] 3 Jan 2007
Gary,
The only metal shear I have direct experience with is the Accu Cutter.
I bought it last year at the ARA show, after looking at a couple of other models also on display. I do not regret my decision one bit, in fact many times I have said to myself, "Self, I'm so glad I bought that cutter. I could not have done this without it".
Unfortunately I have never answered myself so I don't know what myself thinks...but *I* think it's GREAT and highly recommend it.