Full Version: Meistergram Servo
From: clay (CLAY_J1955) [#1]
14 Jan 2007
To: ALL
what would be the software of choice to run one of these machines??
thanks
Clay
EDITED: 14 Jan 2007 by DGL
From: Stunt Engraver (DGL) [#2]
14 Jan 2007
To: clay (CLAY_J1955) [#1] 14 Jan 2007
Clay,
I think they ran/run on native (proprietary) software.
EDITED: 14 Jan 2007 by DGL
From: clay (CLAY_J1955) [#3]
14 Jan 2007
To: Stunt Engraver (DGL) [#2] 14 Jan 2007
From: Stunt Engraver (DGL) [#4]
14 Jan 2007
To: clay (CLAY_J1955) [#3] Unread
This would be a good question for Mike Mackenzie.
I'll page him. :-)
From: Stunt Engraver (DGL) [#5]
14 Jan 2007
To: laserman (MIKEMAC) [#4] 15 Jan 2007
You've worked extensively with H-Square/Meistergram equipment.
Any words of wisdom for Clay?
Thanks,
From: laserman (MIKEMAC) [#6]
15 Jan 2007
To: clay (CLAY_J1955) [#5] Unread
Clay,
It would depend on the age of the system. Some of these systems used Engravelab and some used Engrave98 which is a windows version of d1.4. Some of the systems even use this old dos based software today.