Full Version: How fast can you go
From: laserman (MIKEMAC) [#10]
20 Feb 2007
To: Bill (ALBILLBERT2000) [#6] 20 Feb 2007
Bill,
You should not have any issues running those speeds. If you are using full field or close to full field then wear and tear on the belts and bearings won't be an issue.
You could easily save even more time by running higher power a little slower speed and 333 dpi. Be sure to use the image enhancements I would do a quick test using these parameters you may be pleasantly surprised.
From: Bill (ALBILLBERT2000) [#11]
20 Feb 2007
To: laserman (MIKEMAC) [#10] 20 Feb 2007
Thanks... I am going to play with my laser this weekend... just to play....
Its been a long time since I just tried different things.. Have had it since xmas now going on two years... havent played in to long.. going to try denem, mylar, cork for coasters..... did some photo mats the other week that was neat did lettering right into the paper photo mat..... going to try engraving my company logo on the back of simulated boards again... for customers to see and heck... just play... yipie.. ooo and lasering blank pdu resins... ovals....
anyone have other crazy suggestions..