Full Version: Another Corel Question
From: Bill (BILLC) [#1]
20 Feb 2007
To: ALL
Can someone tell me how to restore the x y positioning feature on the Corel v10 property bar feature. This is the command on the property bar from the transform section titled "position" and when highlighted, gives the location of an object or guideline in relation to the edge of the page . It has previously been work fine Currently it shows 0.0 in both axis no matter where the object is located. If a location is entered the object will move to a new location by the value entered and still show 0.0. How do I reset it reflect 0.0 to be the top left corner of the page?
I have another computer with V10 which works correctl in the same file. I’m thinking it has something to do with a global preset location (?) but for the life of me can not figure where or how to reset it. I have tried restoring the program from the disc – nothing. Any suggestions would be greatly appreciated.
Thanks in advance
Billc
From: Mike (MIKEN) [#2]
20 Feb 2007
To: Bill (BILLC) [#1] 20 Feb 2007
Bill:
The easy way to do this and more is to view Roy Brewer's tutorial.
http://www.engravingconcepts.com/swf_files/CorelDefaults.html
EDITED: 20 Feb 2007 by MIKEN
From: Bill (BILLC) [#3]
20 Feb 2007
To: Mike (MIKEN) [#2] 20 Feb 2007
Mike,
Problem solved thank you. I looked everywhere except Roy's web site which should have the FIRST place to look for a solution.
Thanks again Mike and thank you Roy Brewer.