Full Version: Scotchbrite?
From: Harvey only (HARVEY-ONLY) [#8]
22 Feb 2007
To: Andrew [#7] 22 Feb 2007
Antares makes a new type spiral cutter for stainless steel. I bought one last year in a .005 tip. Amazingly it works very well when cutting a few thousandths deep. They recommend a spindle speed from 8,000 to 10,000.
Since the tip is so small I use 10,000 RPM and it works well.
From: wizzie (DSMITH) [#9]
22 Feb 2007
To: Andrew [#1] 22 Feb 2007
Hello Andrew,
The best thing we've found for finishing stainless are 'Garryflex Rubber blocks'. Have a look at them at www.atigarryson.co.uk, we get them from our local engineering merchant.
David
From: Andrew [#10]
22 Feb 2007
To: wizzie (DSMITH) [#9] 22 Feb 2007
From: gravure (INFOGRAVE) [#11]
24 Feb 2007
To: Andrew [#1] 2 Apr 2007
Hi Andrew,
I have been engraving and paint filling stainless for some time now.
I put a thin layer of substrate .004"~ on the surface. For the smaller plates I use the laser lites material on the 4" role or the 12x24 sheets for the larger plates. The adhesive does release very well after the engraving is finished. If I am engraving the stainless without the thin material I am certain to polish the nose cone very well and apply some wax on the bottom of it. I have a number of different nose cones from metal to plastic. I typically prefer the larger plastic ones because they are easy to polish. I hope you have the ablility to sharpen your own cutters, because it is a must when working with stainless. Also the quarter round cutters and milling tools work best for me.
I always charge a premium when engraving stainless.
Good Luck...
Glenn
From: Stunt Engraver (DGL) [#12]
25 Feb 2007
To: Andrew [#7] 2 Apr 2007
That should come as music to your ears. Going where others fear to tread (or learn) is the first step in creating an impenetrable niche.