Full Version: Air Assist Levels

From: Goodvol (JIMGOOD) [#7]
24 Feb 2007
To: Cody (BOBTNAILER) [#6] 24 Feb 2007

All this talk about food and a breast! 8-O

You're making me hungry!!!

Jim

From: (Brian) (MOSTLY_HERE) [#8]
25 Feb 2007
To: Goodvol (JIMGOOD) [#1] 25 Feb 2007

The air pump should pump out around 30 psi. There should be a needle valve in your machine to drop the pressure down a bit. That would be helpful if you were cutting something very thin like paper or cloth.

From: Goodvol (JIMGOOD) [#9]
25 Feb 2007
To: (Brian) (MOSTLY_HERE) [#8] 25 Feb 2007

Brian,

I need to check to see if I have an adjustment. The instruction booklet does not discuss any adjustment but the assembly drawing shows an "adjusting screw" so I'm hoping that is for the flow.

I'm showing around 9 psi when I'm vector cutting. The model says the max air pressure is 30 psi so I'm assuming I can adjust it, if needed. I seem to be getting a little more burn than I think I should. I need to also check the location of the flow. Maybe it isn't hitting the right spot. I'll check it out.

Thanks for the help!

Jim

Show messages: All 1-6 7-9

Full Version: Air Assist Levels

Back to thread list | Login

© 2024 Project Beehive Forum