Full Version: Air Assist Levels
From: Goodvol (JIMGOOD) [#9]
25 Feb 2007
To: (Brian) (MOSTLY_HERE) [#8] 25 Feb 2007
Brian,
I need to check to see if I have an adjustment. The instruction booklet does not discuss any adjustment but the assembly drawing shows an "adjusting screw" so I'm hoping that is for the flow.
I'm showing around 9 psi when I'm vector cutting. The model says the max air pressure is 30 psi so I'm assuming I can adjust it, if needed. I seem to be getting a little more burn than I think I should. I need to also check the location of the flow. Maybe it isn't hitting the right spot. I'll check it out.
Thanks for the help!
Jim