Full Version: Vector Cutting Edge
From: Mike (MIKEN) [#5]
25 Feb 2007
To: Engravin' Dave (DATAKES) [#4] 25 Feb 2007
On my Universal the carriage was out of alignment. That is if you pulled the carriage all the way to the front the right side would be at the stop but the left side was one inch or more away from the stop.
Something had blocked the movement and knocked it out of alignment.
From: (Brian) (MOSTLY_HERE) [#6]
25 Feb 2007
To: Engravin' Dave (DATAKES) [#1] 26 Feb 2007
Hey Dave,
I have had the same thing on my 24 EX. I had to keep lowering my speed to cut through. It seemed the longer I ran, the worse it got. I also had noticed that my rastering small fonts was getting unacceptable. The strange thing I had noticed, the closer to the laser tube the, the weaker the power seemed. I contacted Epilog and determined the laser tube was the culprit. After the new tube it has been better but, I still can notice some "cold spots" on the engraving table. :@ I'd be interested in what you find out.
From: Engravin' Dave (DATAKES) [#7]
26 Feb 2007
To: (Brian) (MOSTLY_HERE) [#6] 26 Feb 2007