Full Version: Vector Cutting Edge
From: (Brian) (MOSTLY_HERE) [#6]
25 Feb 2007
To: Engravin' Dave (DATAKES) [#1] 26 Feb 2007
Hey Dave,
I have had the same thing on my 24 EX. I had to keep lowering my speed to cut through. It seemed the longer I ran, the worse it got. I also had noticed that my rastering small fonts was getting unacceptable. The strange thing I had noticed, the closer to the laser tube the, the weaker the power seemed. I contacted Epilog and determined the laser tube was the culprit. After the new tube it has been better but, I still can notice some "cold spots" on the engraving table. :@ I'd be interested in what you find out.
From: Engravin' Dave (DATAKES) [#7]
26 Feb 2007
To: (Brian) (MOSTLY_HERE) [#6] 26 Feb 2007