Full Version: Ikon Metal Contest Winners (w/photos)
From: IKON_Kim [#18]
9 Mar 2007
To: Dave Jones (DAVERJ) [#17] 9 Mar 2007
Hello Dave,
At the top of the IKONMetal forum you can find in the top bar a link that is called "Datasheet/Pricing". This link opens up a PDF with more information on the product. Also if you click to enter the "Ikonics Discussion" some questions and answers have been posed in there.
Kimberly
EDITED: 9 Mar 2007 by IKON_KIM
From: IKON_Kim [#19]
9 Mar 2007
To: Engravin' Dave (DATAKES) [#13] 9 Mar 2007
Engravin' Dave,
I emailed another at IKONICS here and this was his reply:
I understand what he is going through. The grit will deflect for a minute or two until you will see an etch. I would recommend using 150-grit silicon carbide abrasive to achieve depth quicker. I typically blast at 60-80 PSI with a pressure pot system. Most people have capabilities to blast up to 50-60 psi so I would say crank it up to them. The 180 silicone carbide grit will still work but it is lighter than 150 grit so the impact is lesser. Therefore, take a little longer to blast with depth. Thank you for using IKONMetal! Better luck to you!
Kimberly
From: Dave Jones (DAVERJ) [#20]
9 Mar 2007
To: IKON_Kim [#18] 11 Mar 2007
From: LaZerDude (C_BURKE) [#21]
10 Mar 2007
To: gt350ed [#7] 10 Mar 2007
Ed,
What EVER it is that I did to offend you, I humbly apologize.
From: gt350ed [#22]
10 Mar 2007
To: LaZerDude (C_BURKE) [#21] 10 Mar 2007
From: LaZerDude (C_BURKE) [#23]
10 Mar 2007
To: gt350ed [#22] 10 Mar 2007
Show messages: 1-17 18-23