Full Version: Engraving aluminum
From: Harvey only (HARVEY-ONLY) [#16]
12 Mar 2007
To: James (TILER02) [#15] 12 Mar 2007
James,
Please do not take that track. Someone missed what you replied to, and made a mistake. You did not. Forgive him his mistake and stick around with posting. Our community would be lessened without even one of its members.
Harvey
From: Andrew [#17]
12 Mar 2007
To: James (TILER02) [#15] 12 Mar 2007
No offence meant James, and you certainly didn't offend me - I have a slightly thicker skin than that! I checked your profile before replying and this gave me no clues as to your background.
I never questioned that you do not know what you are talking about. I am relatively new to this industry and when posts come up on mechanical engraving they are of high interest to me. They are few and far between with the majority of post being on laser engraving.
I do not reperesent this board - it would be a shame for one person to upset you to the point of you no longer contributing.
From: Cody (BOBTNAILER) [#18]
12 Mar 2007
To: Tony (ANTE) [#8] 13 Mar 2007
Tony,
I'm ashamed that I didn't think to do that!! In my feeble little mind, I thought that the nose cone and manual cutter depth were mutually exclusive!! DOH!!
That's sad....I was trained better than that!!
To answer a question from another post - the "new" items will be black anodized aluminum. I simply forgot to mention the fact that they will be black. Laser engraving these things will make life soooo much better!
Thanks to all for your input!
Cody
From: James (TILER02) [#19]
12 Mar 2007
To: Andrew [#17] 24 Mar 2007
EDITED: 12 Mar 2007 by TILER02
From: logojohn [#20]
12 Mar 2007
To: James (TILER02) [#19] Unread
From: Stunt Engraver (DGL) [#21]
12 Mar 2007
To: James (TILER02) [#19] Unread
I wasn't around for the supposed fireworks.
What is it you seem to get every time you post?
From: Peter [#22]
13 Mar 2007
To: Stunt Engraver (DGL) [#21] 13 Mar 2007
I wasn't around for the supposed fireworks.
What is it you seem to get every time you post?
David "The Stunt Engraver" Lavaneri
DGL Engraving
Port Hueneme, CA
It would appear ..a Smack in the back of the head with a piece of 4x2 >.<
Hey James...take it from me..Im in the same boat as you :> So I act like a duck...and let the water roll off my back.. :O)
Dont take it to heart, most of these chums are a good lot.. :B
regards
Peter
Show messages: 1-15 16-22