Full Version: Engraving aluminum

From: Cody (BOBTNAILER) [#18]
 12 Mar 2007
To: Tony (ANTE) [#8] 13 Mar 2007

Tony,

I'm ashamed that I didn't think to do that!! In my feeble little mind, I thought that the nose cone and manual cutter depth were mutually exclusive!! DOH!!

That's sad....I was trained better than that!!

To answer a question from another post - the "new" items will be black anodized aluminum. I simply forgot to mention the fact that they will be black. Laser engraving these things will make life soooo much better!

Thanks to all for your input!

Cody

---

From: James (TILER02) [#19]
 12 Mar 2007
To: Andrew [#17] 24 Mar 2007

I filled out the profile if you would like to look. Andrew it was not just you, I seem to get that every time I post. It does anoy me.

EDITED: 12 Mar 2007 by TILER02

---

From: logojohn [#20]
 12 Mar 2007
To: James (TILER02) [#19] Unread

I feel your pain ;-)

---

From: Stunt Engraver (DGL) [#21]
 12 Mar 2007
To: James (TILER02) [#19] Unread

James,

I wasn't around for the supposed fireworks.

What is it you seem to get every time you post?

---

From: Peter [#22]
 13 Mar 2007
To: Stunt Engraver (DGL) [#21] 13 Mar 2007

It would appear ..a Smack in the back of the head with a piece of 4x2 >.<

Hey James...take it from me..Im in the same boat as you :> So I act like a duck...and let the water roll off my back.. :O)

Dont take it to heart, most of these chums are a good lot.. :B

regards

Peter

---

Show messages:  1-17  18-22

Back to thread list | Login

© 2024 Project Beehive Forum