Full Version: Vector Cutting Method
From: Engravin' Dave (DATAKES) [#17]
12 Mar 2007
To: Doc (GREAT_ATLANTIC) [#16] 12 Mar 2007
Jim,
Thank you.
I did a test run on a small piece of the same material which resulted in such a nice snug fit, I decided to run without an adjustment. I used Rowmark's LaserMax material from Johnson Plastics.
Mike offered very sound advice. The figure will likely need to be adjusted based on your machine, as well as the material you are cutting, be it wood, plastic, acrylic, etc.
EDITED: 12 Mar 2007 by DATAKES
From: Stunt Engraver (DGL) [#18]
12 Mar 2007
To: Engravin' Dave (DATAKES) [#15] 12 Mar 2007
Did you use typical engraving stock for the three colors?
From: Engravin' Dave (DATAKES) [#19]
12 Mar 2007
To: Stunt Engraver (DGL) [#18] 12 Mar 2007
From: Stunt Engraver (DGL) [#20]
12 Mar 2007
To: Engravin' Dave (DATAKES) [#19] 12 Mar 2007
I'm glad you explained the plaque was intentionally shaped as a trapezoid.
I thought it was a weird camera angle. :-)
Message 6287.21 was deleted
From: Stunt Engraver (DGL) [#22]
12 Mar 2007
To: Engravin' Dave (DATAKES) [#21] 12 Mar 2007
So far, Chroma-Crystal would fall under digital imaging. If the subject became rampant, we could create a specific folder.
From: Mike (MIKEN) [#23]
12 Mar 2007
To: Engravin' Dave (DATAKES) [#20] 12 Mar 2007
Great work and a kind we don't see enough of.
From: Engravin' Dave (DATAKES) [#24]
12 Mar 2007
To: Mike (MIKEN) [#23] 12 Mar 2007
Show messages: 1-16 17-24