Full Version: Legend plates
From: Mike (MIKEN) [#4]
17 Mar 2007
To: Ed (EMERY) [#3] 17 Mar 2007
These are fairly easy to make. first make a box, then a circle and weld them together. Make another circle for the switch opening and center it
then make a small box (the key to keep the plate in place) and weld that to the smaller circle and you're ready to engrave.
From: Ed (EMERY) [#5]
17 Mar 2007
To: Mike (MIKEN) [#4] 17 Mar 2007
From: Mike (MIKEN) [#6]
17 Mar 2007
To: Ed (EMERY) [#5] 17 Mar 2007
Johnson Plastics also sells them.
From: Ed (EMERY) [#7]
17 Mar 2007
To: Mike (MIKEN) [#6] 19 Mar 2007
Hi Mike
Here's 3 I just did by following your instructions. That weld command is fun!
From: Mike (MIKEN) [#8]
19 Mar 2007
To: Ed (EMERY) [#7] 19 Mar 2007
Corel is really quite easy if you can find all the keys. This forum and the corel site are both great at helping you along.
But now you know how to customize these individually for your customers.
Good Job!