Full Version: Is Alucabond a laserable material?

From: gravure (INFOGRAVE) [#5]
18 Mar 2007
To: Larry B (PALMETTO) [#4] 19 Mar 2007

You are correct, it is about 200$. Once I get the settings I will post them. I use the material to apply my vector and digital prints. It is excellent material for exterior applications. It would be difficult to work with for engraving purposes because of the fabrication unless you have the proper tools.
Glenn

From: Larry B (PALMETTO) [#6]
19 Mar 2007
To: gravure (INFOGRAVE) [#5] 24 Mar 2007

Well, I was just curious as to whether anybody had used it or not. If I was going to cut it, I'm sure my CNC would do a good job on it. The stone finishes that they have are very attractive and it was a thought that they would make nice products of some kind. I like to experiment with new or different materials.

From: Ray (STAMP) [#7]
24 Mar 2007
To: gravure (INFOGRAVE) [#5] 24 Mar 2007

Hi Glenn,
Just curious reading your info I wonder are you born in Quebec and live in Nova-Scotia like me or born in Nova-Scotia and live in Quebec .
Ray

From: gravure (INFOGRAVE) [#8]
24 Mar 2007
To: Ray (STAMP) [#7] 26 Mar 2007

Hi Ray,

Born in Nova Scotia and now living in Quebec. I still have an store in NS.
I travel back to NS every few months. Lately things have been busy here so my trips back are limited. I am doing some consulting on the side here as well. I have a number of engraving shops that I am helping out with software, machines, materials etc.

Where are you located in NS?

I moved here 3 years ago. I am located in St-Lazare.

We should exchange contact info.

Regards,

Glenn

Show messages: All 1-4 5-8

Full Version: Is Alucabond a laserable material?

Back to thread list | Login

© 2024 Project Beehive Forum