Full Version: Is Alucabond a laserable material?

From: Larry B (PALMETTO) [#6]
19 Mar 2007
To: gravure (INFOGRAVE) [#5] 24 Mar 2007

Well, I was just curious as to whether anybody had used it or not. If I was going to cut it, I'm sure my CNC would do a good job on it. The stone finishes that they have are very attractive and it was a thought that they would make nice products of some kind. I like to experiment with new or different materials.

From: Ray (STAMP) [#7]
24 Mar 2007
To: gravure (INFOGRAVE) [#5] 24 Mar 2007

Hi Glenn,
Just curious reading your info I wonder are you born in Quebec and live in Nova-Scotia like me or born in Nova-Scotia and live in Quebec .
Ray

From: gravure (INFOGRAVE) [#8]
24 Mar 2007
To: Ray (STAMP) [#7] 26 Mar 2007

Hi Ray,

Born in Nova Scotia and now living in Quebec. I still have an store in NS.
I travel back to NS every few months. Lately things have been busy here so my trips back are limited. I am doing some consulting on the side here as well. I have a number of engraving shops that I am helping out with software, machines, materials etc.

Where are you located in NS?

I moved here 3 years ago. I am located in St-Lazare.

We should exchange contact info.

Regards,

Glenn

Show messages: All 1-5 6-8

Full Version: Is Alucabond a laserable material?

Back to thread list | Login

© 2024 Project Beehive Forum