Full Version: Hold downs for scissors...

From: BobT [#14]
24 Mar 2007
To: Brett (BHALLE) [#1] 24 Mar 2007

I am not sure if it is appropriate for your engraver, but, I recently had a number of wood handled tools to engrave, four sizes and shapes, on my laser. I formed holders from Polymer Clay. You bake the clay at low temp in the oven and it gets real hard. It was a great way to go for me.

From: Stunt Engraver (DGL) [#15]
24 Mar 2007
To: BobT [#14] 24 Mar 2007

Bob,

Bondo (automotive, body shop staple) molds have also been suggested, in the past, as a means of holding unruly objects.

From: Mike (MIKEN) [#16]
24 Mar 2007
To: ALL

here's a picture using woodworking type clamps. they hold just fine.

From: UncleSteve [#17]
24 Mar 2007
To: Mike (MIKEN) [#16] 24 Mar 2007

Aw, c'mon Mike! That looks way too simple and effective!!! ;-)

Thanks for one of the least expensive, reusable, easy to find solutions to what is a more common problem than one would expect. :D

Show messages: All 1-13 14-17

Full Version: Hold downs for scissors...

Back to thread list | Login

© 2024 Project Beehive Forum