Full Version: Multi mat, fat-mat, sticky pads
From: John (ICTJOHN) [#27]
6 Apr 2007
To: gt350ed [#26] 9 Apr 2007
Ed,
Well, if you're gonna join the conversation in the middle, I can see where you might turn red.... HO Ho HO ho ROFL!
:'D :B
you should have look at the earlier posts! :P
~
From: Stunt Engraver (DGL) [#28]
6 Apr 2007
To: gt350ed [#26] 9 Apr 2007
You had to be there!
Then again, maybe it's a good thing you weren't.
:B
From: Tony (ANTE) [#29]
6 Apr 2007
To: gt350ed [#26] 9 Apr 2007
Ed,
It is hard to explain unless you have one. I use multi mat to hold down 1.5" aluminum disks when burnishing. After prolonged usage paint coating from disks gets all over mat and it needs to be cleaned. I run tap water on it to get rid of dirt, and dry it with hair drier, back in production.
One drawback with multi mat is that it leaves oily residue on table top and if plates need tape on them for attaching the tape should be applied before placing them on mat.
Tony
From: Dave Jones (DAVERJ) [#30]
6 Apr 2007
To: gt350ed [#26] 9 Apr 2007